| Acknowledgments | | ix | (2) |
| Intrduction | | xi | |
| Chapter 1 Switching Technology Primer | | | 1 | (34) |
| | | 2 | (1) |
| | | 2 | (8) |
| | | 10 | (10) |
| The Briefest of Introductions to ATM | | | 20 | (13) |
| | | 33 | (2) |
| | | 35 | (44) |
| | | 36 | (1) |
| | | 36 | (10) |
| | | 46 | (6) |
| | | 52 | (5) |
| Spanning Tree Optimization | | | 57 | (6) |
| | | 63 | (4) |
| | | 67 | (3) |
| | | 70 | (7) |
| | | 77 | (2) |
| Chapter 3 ATM Operation and WAN Switching | | | 79 | (48) |
| | | 80 | (1) |
| Introduction to UNI Signaling | | | 80 | (8) |
| ATM Routing and NNI Signaling | | | 88 | (15) |
| | | 103 | (5) |
| | | 108 | (6) |
| | | 114 | (2) |
| | | 116 | (1) |
| | | 117 | (8) |
| | | 125 | (2) |
| Chapter 4 Configuring Workgroup Switches | | | 127 | (88) |
| | | 128 | (1) |
| Connecting a 2900XL Series Switch into Your Network | | | 128 | (8) |
| | | 136 | (1) |
| | | 137 | (2) |
| Modifying the Configuration | | | 139 | (14) |
| VLAN Assignment and Inter VLAN Communication | | | 153 | (8) |
| Using the SPAN Port for LAN Analysis | | | 161 | (1) |
| Saving and Retrieving Configurations | | | 162 | (2) |
| Typical Base Configuration | | | 164 | (3) |
| | | 167 | (2) |
| | | 169 | (42) |
| | | 211 | (4) |
| Chapter 5 Implementing Large-Scale Switched LANs | | | 215 | (84) |
| | | 216 | (1) |
| Catalyst 5000 and 5500 Hardware | | | 216 | (10) |
| Catalyst 5K Initial Configuration | | | 226 | (19) |
| Ethernet Module Configuration | | | 245 | (25) |
| Route Switch Module Support for VLANs | | | 270 | (5) |
| Catalyst 5K Token Ring Implementation | | | 275 | (9) |
| | | 284 | (4) |
| ATM Operation on Catalyst 5K Switches | | | 288 | (8) |
| | | 296 | (3) |
| Chapter 6 Implementing ATM Switching | | | 299 | (60) |
| | | 300 | (1) |
| Overview of ATM Processors for Cisco Routers | | | 300 | (3) |
| Basic ATM Processor Configuration | | | 303 | (7) |
| Configuring Classic IP Over ATM on ATM Router Interfaces (RFC 1577) | | | 310 | (6) |
| Overview of Configuring PPP Services on ATM Router Interfaces | | | 316 | (2) |
| Introduction to the LS1010 | | | 318 | (1) |
| Basic LS1010 Configuration | | | 318 | (12) |
| IISP and PNNI for the LS1010 | | | 330 | (5) |
| Configuring LANE on the LS1010 | | | 335 | (5) |
| Overview of LANE 2.0 and MPOA for the LS1010 | | | 340 | (5) |
| | | 345 | (10) |
| | | 355 | (4) |
| Chapter 7 Implementing Switched Networks | | | 359 | (40) |
| | | 360 | (1) |
| Network Implementation Goals | | | 361 | (15) |
| Common Switched Network Design | | | 376 | (10) |
| Two Alternatives in Putting the Three Layers Together | | | 386 | (2) |
| Redesigning the Routed to a Switched Network | | | 388 | (2) |
| Redesigning Acme's Routed Network | | | 390 | (6) |
| | | 396 | (3) |
| Index | | 399 | |
